Products

CAN4VSCP based products

Place An Alternate Description Here!
CAN4VSCP modules are designed to work on a bus based system which use ordinary RJ-45 connectors and is powered with 9-28V DC over the same cable. This means there is no need for a separate power cable. All that is needed is a CAT5 or better twisted pair cable. Bus length can be a maximum of 500 meters with drops of maximum 24 meters length (up to a total of 120 meters). As for all CAN4VSCP modules the communication speed is fixed at 125 kbps.

All VSCP modules contains information of there own setup, manual, hardware version, manufacturer etc. You just ask the module for the information you need and you will get it. When they are started up they have a default functionality that often is all that is needed to get a working setup. If the module have something to report it will send you an event and if it is setup to react on a certain type of event it will do it's work when you send event(s) to it.

Paris - Relay Module

Kelvin NTC10KA - Temperature module (one internal, five external sensors)

Kelvin 1-wire - Temperature module (one internal, eight external sensors)

Frankfurt RS-232 - Serial to CAN4VSCP interface Module

Odessa - Prototype module

Beijing - General I/O module

Accra - General counter module

CAN4VSCP Power Injector

Vilnius - Analog to Digital module with I/O

San Francisco - Barometric pressure module -- Available for pre-order


Ethernet & TCP/IP based products

Ethernet & TCP/IP based products Our Ethernet product line communicate using the raw Ethernet protocol/VSCP Multicast or TCP/IP. This means that they don't need any configuration after it is connected to your network. You can just use it. Power is supplied over the RJ45 connector so it's possible to power the module from a remote location using 9-28V DC. This means there is no need for a separate power cable.

As all VSCP modules they contain information of there own setup, manual, hardware version, manufacturer etc. You just ask the module for the information you need and you will get it. When they are started up they have a default functionality that often is all that is needed to get a working setup. If the module have something to report it will send you an event and if it is setup to react on a certain type of event it will do it's work when you send event(s) to it.

Frankfurt Eth A module -- under design

Frankfurt Eth B module -- under design

VSCP wireless products

Place An Alternate Description Here! This is 802.15.4 VSCP wireless modules using 6LowPan but also 433MHz and Bluetooth. Modules in this series got high security and work right after installation. This is normally battery powered devices.

Roma - 433 MHz wireless receiver/transmitter -- under design

Frankfurt BLE - Connect cellular phone with CAN4VSCP -- under design

VSCP wifi products

Place An Alternate Description Here! This is a series of wifi enabled modules.

Frankfurt Wifi - Connect CAN4VSCP segment with Wifi -- under design





Other products

Place An Alternate Description Here! We also make some products that support our product range.

PIC Programming adapter