CAN4VSC Power Injector


CAN4VSC Power Injector

With the power injector you can power the CAN4VSCP bus and also power up to 16 CAN4VSCP modules using the daisy chain connector. This is a perfect companion board to use when you need to connect a number of CAN4VSCP boards in a cabinet and then connect them to thw world.

It also have two 120 ohm terminations that can be activated if needed.

It is also possible to get the module with a resettable fuse that allow a maximum of 500 mA for all modules connected to the board. The fuse will trip at about 800 mA. This can be a good safety precaution for wired networks.

Available in the FrogShop.


There is no manual for this module.


Schematics Reversion C


There is no firmware in this module.

MDF - Module Description File

This module does not have a Module Description File.


There are no recipes.