This is an old revision of the document!
When things does not work we have to search for the reason for why it does not work. As always this means to be patient and systematic. Here we list some info on touble shooting a CAN4VSCP bus.
Power is the first thing to check. If the power lamp (RED LED) on the module lights up the this is probably OK. If you have you bus connected with a CAT-5 or similar network cable you should have 9-28V on the orange/orange-white/green-white cables and 0V on the brown/brown/white/green cables. You have the complete pinout here.
Very common problem. CAN/CAN4VSCP requires that there is two active nodes on the bus at the same time. If not CAN/CAN4VSCP will not work. If you have equipment so you can look at the bus traffic in such a situation you will see a lot of traffic. This is the same event sent over and over again because it is never acknowledged. Remember that a Frankfurt RS-232 or other CAN adapter is a valid active device only when it is active/open.
This node probably have some problem with its receive channel. Most often a cable problem sometimes a tranceiver problem on the board.