Adding pull-ups/downs to Beijing

Here is a great tip from a customer (Maarten Zanders in Belgium). His word below.

Here’s a tip for if you use Beijing to process buttons. If you want to add stronger pull-ups (the PIC’s internal pullups are too weak to be used on physical -long- wire), there’s a component from “the old days” that can help you out: SIL resistor arrays.

Picture attached shows the resistor array in place. I think this position results in a pull down configuration.

I only have the 10 pin version at hand (9 pull-ups) but 11pin versions also exist.

Paradise of the Frog AB Brattbergavägen 17, 820 50 LOS, SWEDEN
email: phone: +46 (0)8 40011835

recipes.txt · Last modified: 2018/02/08 17:15 (external edit)