Decision Matrix

The full functionality of the decision matrix is explained in the specification.

Beijing have a decision matrix consisting of eight entries. This matrix can be used to control the I/O channels. Possible actions are listed in the table below.

Action Action code Parameter Description
NOOP 0 Not used No operation. Will do absolutely nothing.
SET 1 Channel (0-1) Set output of I/O channel high.

Set the output of the I/O channel given by the argument to its high state. The argument is an integer where 0 is output 0 and so on and can be in the range 0-1.
CLR 2 Channel (0-1) Set output of I/O channel low.

Set the output of the I/O channel given by the argument to its low state.
The argument is an integer where 0 is output 0 and so on and can be in the range 0-1.
TOGGLE 3 Channel (0-1) Toggle output for channel

Toggle output four output I/O channel given by argument. The argument is an integer where 0 is output 0 and so on and can be in the range 0-1. Does not have any meaning for a channel set as input.
STATUS 4 sendorindex Works the same as when the module receive a CLASS1.CONTROL,SYNC event with the exception that zone/sub zone always is the same as of the module.
STATUSALL 5 Not used same as STATUS above but without the sendorindex argument. Will report info for all channels and types.

Example

You want to activate output I/O 0 when a CLASS1.CONTROL, TurnOn, Type=5 event is received.

A matrix row consist of

Byte Description
0 oaddr
1 flags
2 class-mask
3 class-filter
4 type-mask
5 type-filter
6 Action code
7 Action parameter

So for example if you populate the row with the following values

Byte Value Description
0 0x00 oaddr
1 0x80 flags
2 0xff class-mask
3 0x1e class-filter
4 0xff type-mask
5 0x05 type-filter
6 0x01 Action code
7 0x01 Action parameter
  • oaddr set to zero as i is not used.
  • flags have one bit set. Enable row. We could have set bit 4 Match Zone to test zone also trigger DM.
  • class-mask is set to 0xff as we have just one event we will trigger on.
  • class-filter is set to CLASS1.CONTROL.
  • type-mask is set to 0xff as we have just one event we will trigger on.
  • type-filter is set to 5 which is TurnOn.
  • Action code i set to the SET action.
  • Action parameter 1 is I/O 0 so this channel will be set high if configured as an output.

If you double click a decision matrix row a dialog comes up which help you to set the values.



Paradise of the Frog AB Brattbergavägen 17, 820 50 LOS, SWEDEN
email: info@paradiseofthefrog.com phone: +46 (0)8 40011835
web: http://www.paradiseofthefrog.com

 
decisionmatrix.txt · Last modified: 2015/12/16 12:20 by admin