Here the events sent by the module is described.
Event | Description |
---|---|
CLASS1.INFORMATION (20) Type=3, On | If enabled the event is sent when a relay goes to its active state. Index is 0 for relay 1, 1 for relay 2 and so on. zone and sub-zone set accordingly. Sub-zone for relay is used if it's not zero. Data: Byte 0: Index. Byte 1: Zone Byte 2: Subzone. |
CLASS1.INFORMATION (20) Type=4, Off | If enabled the event is sent when a relay goes to its inactive state. Index is 0 for relay 1, 1 for relay 2 and so on. Zone and sub-zone set accordingly. Sub-zone for relay is used if it's not zero. Data: Byte 0: Index. Byte 1: Zone Byte 2: Subzone. |
CLASS1.INFORMATION (20) Type=24, Stop | Index is 0 for relay 1, 1 for relay 2 and so on. Zone and sub-zone set accordingly. Sub-zone for relay is used if it's not zero. Data: Byte 0: Index. Byte 1: Zone Byte 2: Subzone. |
CLASS1.INFORMATION (20) Type=25, Start | Index is 0 for relay 1, 1 for relay 2 and so on. Zone and sub-zone set accordingly. Sub-zone for relay is used if it's not zero. Data: Byte 0: Index. Byte 1: Zone Byte 2: Subzone. |
CLASS1.ALARM (1) Type=2, Alarm occurred | Index is 0 for relay 1, 1 for relay 2 and so on. Data: Byte 0: Index. Byte 1: Zone Byte 2: Subzone. |