Decision Matrix
The full functionality of the decision matrix is explained in the specification.
Paris have a decision matrix consisting of eight entries. This matrix can be used to control the relays. Possible actions are listed in the table below.
| Action | Action code | Parameter | Description |
|---|---|---|---|
| NOOP | 0 (0x00) | Not used | No operation. Will do absolutely nothing. |
| ACTIVATE | 1 (0x01) | Relays to activate (bit array) | Activate relay(s) given by argument. The argument is a bit array where bit 0 is relay 1 and so on. That is a position with a set bit will activate the corresponding relay. Byte 1 is Zone and byte 2 is sub-zone and must be equal to register content to trigger action. |
| DEACTICATE | 2 (0x02) | Relays to deactivate (bit array) | Deactivate relay(s) given by argument. The argument is a bit array where bit 0 is relay 1 and so on. That is a position with a set bit will inactivate the corresponding relay. Byte 1 is Zone and byte 2 is sub-zone and must be equal to register content to trigger action. |
| PULSEON | 3 (0x03) | Relays to pulse (bit array) | Pulse relay(s) given by argument. The argument is a bit array where bit 0 is relay 1 and so on. That is a position with a set bit will toggle the corresponding relay. Byte 1 is Zone and byte 2 is sub-zone and must be equal to register content to trigger action. |
| - | 4 (0x04) | - | Reserved. |
| - | 5 (0x05) | - | Reserved. |
| - | 6 (0x06) | - | Reserved. |
| - | 7 (0x07) | - | Reserved. |
| - | 8 (0x08) | - | Reserved. |
| - | 9 (0x09) | - | Reserved. |
| STATUS | 10 (0x0a) | Relays to send status for (bit array) | Send relay status. The argument is a bit array where bit 0 is relay 1 and so on. That is a position with a set bit will have a status event sent for the corresponding relay. |
| - | 11 (0x0b) | - | Reserved. |
| - | 12 (0x0c) | - | Reserved. |
| - | 13 (0x0d) | - | Reserved. |
| - | 14 (0x0e) | - | Reserved. |
| - | 15 (0x0f) | - | Reserved. |
| DISABLE | 16 (0x10) | Relays to disable (bit array) | Disable relay(s) given by argument. The argument is a bit array where bit 0 is relay 1 and so on. That is a position with a set bit will disable the corresponding relay. Byte 1 is Zone and byte 2 is zone page and must be equal to register content to trigger action. |
Example
tbd
email: info@paradiseofthefrog.com phone: +46 (0)8 40011835
web: http://www.paradiseofthefrog.com