The SLCAN mode

The SLCAN mode is for use with the socketcan interface available on Linux. SLCAN is a CAN driver for several 'low cost' CAN interfaces that are attached via serial lines or via USB-to-serial adapters using the LAWICEL ASCII protocol You can use the standard socketcan tools in this mode.

:!: The Frankfurt RS-232 just implements a limited command set of SLCAN, just the commands needed to make the Frankfurt RS-232 usable with socketcan for VSCP. Please contact Lawicel AB to buy a unit that confirms to the full set of commands if you have that need.




Paradise of the Frog AB Brattbergavägen 17 820 50 LOS SWEDEN
email: info@grodansparadis.com phone: +46 (0)8 40011835
web:http://www.grodansparadis.com

 
the_slcan_mode.txt · Last modified: 2015/10/06 09:44 by admin